Yolinux.com

SSL_do_handshake manpage

Search topic Section


SSL_do_handshake(3)		    OpenSSL		   SSL_do_handshake(3)



NAME
       SSL_do_handshake - perform a TLS/SSL handshake

SYNOPSIS
	#include <openssl/ssl.h>

	int SSL_do_handshake(SSL *ssl);

DESCRIPTION
       SSL_do_handshake() will wait for a SSL/TLS handshake to take place. If
       the connection is in client mode, the handshake will be started. The
       handshake routines may have to be explicitly set in advance using
       either SSL_set_connect_state(3) or SSL_set_accept_state(3).

NOTES
       The behaviour of SSL_do_handshake() depends on the underlying BIO.

       If the underlying BIO is blocking, SSL_do_handshake() will only return
       once the handshake has been finished or an error occurred.

       If the underlying BIO is non-blocking, SSL_do_handshake() will also
       return when the underlying BIO could not satisfy the needs of
       SSL_do_handshake() to continue the handshake. In this case a call to
       SSL_get_error() with the return value of SSL_do_handshake() will yield
       SSL_ERROR_WANT_READ or SSL_ERROR_WANT_WRITE. The calling process then
       must repeat the call after taking appropriate action to satisfy the
       needs of SSL_do_handshake().  The action depends on the underlying BIO.
       When using a non-blocking socket, nothing is to be done, but select()
       can be used to check for the required condition. When using a buffering
       BIO, like a BIO pair, data must be written into or retrieved out of the
       BIO before being able to continue.

RETURN VALUES
       The following return values can occur:

       0   The TLS/SSL handshake was not successful but was shut down
	   controlled and by the specifications of the TLS/SSL protocol. Call
	   SSL_get_error() with the return value ret to find out the reason.

       1   The TLS/SSL handshake was successfully completed, a TLS/SSL
	   connection has been established.

       <0  The TLS/SSL handshake was not successful because a fatal error
	   occurred either at the protocol level or a connection failure
	   occurred. The shutdown was not clean. It can also occur of action
	   is need to continue the operation for non-blocking BIOs. Call
	   SSL_get_error() with the return value ret to find out the reason.

SEE ALSO
       SSL_get_error(3), SSL_connect(3), SSL_accept(3), ssl(3), bio(3),
       SSL_set_connect_state(3)



1.0.2k				  2017-01-26		   SSL_do_handshake(3)